Create high-quality, personalized tumblers with our 450 ml stainless steel sublimation tumblers! These tumblers feature a stainless steel inner tank encased in a polymer outer wrap for rich, full color transfers and a durable, premium feel.
Specifications
- Stainless steel sublimation tumbler blanks
- Capacity: 15oz.
- Printable polymer outer wrap
- Stainless steel inner tank
- Can contain cold or hot beverages
- Food grade material, BPA free
- For use with a Mug Press AND Aluminum Insert Tool, or Silicone Wrap
*If you are using a mug press, the aluminum insert tool IS required!
Note: Be sure to remove lid before sublimating!
Note: Use the Latte Element for this item!
4-in-1 Mug Press
Press Temperature: 320°F
Time: 180 Seconds
Pressure: Light
- Pre heat jig to 320F
- Attach sublimation transfer paper with image printed in reverse to the tumbler with thermal tape
- Place pre heated Aluminum Insert Tool into tumbler
- Place tumbler in press at the press temperature, and close the element around the tumbler
- Press for the specified time above needed using specified pressure
- If the image begins to look blurry, or burnt brown by over-pressing, decrease time by 15 - 30 seconds
- Once done, remove the tumbler from the press and remove the transfer paper immediately
- Allow the tumbler to cool completely before use
Oven Settings
Press Temperature: 400°F
Time: 5 - 6 Minutes
(test in your oven for accurate time)
- Attach reversed printed image to tumbler with thermal tape
- Place tumbler in silicone wrap
- Place in oven preheated to 400°F for approximately 5 - 6 minutes (test to determine best timing!)
- Afterwards, remove silicone wrap and paper immediately
- Allow the tumbler to cool completely before use
